Raised Barrel Hinges

Specify hand of door when ordering
Specify whether hinges are for square edge or beveled edge doors on the hinge side
Specify equal or unequal leaves when ordering

• For application where doors are set deep on a wide frame
• Frame leaf may be either surface mounted or mortised as illustrated in sketches below
• Available special for doors that must open 180 degrees
• Supply detail of door and frame condition
• For other hinge types than listed below, consult factory

Wide Throw Hinge

• A full mortise hinge with wider than normal leaves, positions the door out further, when open, than with conventional hinges
• Normally used when doors are set in a reveal and are required to open 180°
• Specify whether hinges are for square or beveled edge doors on the hinge side when ordering

REFFER TO HINGE WIDTH PAGE FOR MORE DETAIL

Hinge Swaging

• Swaging is a slight offset of the hinge leaf at the barrel which permits the leaves to come closer together
  when parallel
• Hinges are slightly less in width when both leaves are not swaged. Not swaged leaf is shorter when only one leaf is swaged. EXCEPTION: Specify “leaves must be equal” when ordering template hinges for metal door and metal frame (furnished all machine screws) when both leaves must be the same width
• When leaves are parallel, standard swaging for most architectural hinges provides a 1⁄16" (1.6mm) clearance